6pcs 4x6 Purple Matte Flat Vinyl Wrap Emblem Overlay Sticker Decal Front Rear Film Sheet Not Pre-Cut Free Tool Kit

6pcs 4x6 Purple Matte Flat Vinyl Wrap Emblem Overlay Sticker Decal Front Rear Film Sheet Not Pre-Cut Free Tool Kit

Tool Kit Requirement

Limited 1 Set of Tool Kit for each Account ONLY regardless of quantity purchase

Included

• (6) 6 by 4 Vinyl Sheets. (Not a precut letter) (Emblem not included)
• These are not precut because a vinyl sheet is easier to apply than a precut decal. A precut decal requires perfect alignment, while a sheet allows you trim off the excess vinyl. (Allowing more room for error)

This kit will not work with some model years because the emblems will not allow the vinyl to adhere properly

Installation Instructions

• Recommended installation weather is to be above 50 degrees and not to be in direct sun light
• If you end up with small bubbles under the decal, they will dissipate in the heat after a couple days

Important

• Use the following step if you are having issues getting the decal to stay stuck down in the corners of the emblem. It will also help if the decal is bunching up around the curves
• Lightly heat the decal with a hair dryer and carefully use the squeegee to force the decal into the corners of the emblem. For the curves, it helps to slide the wedge tool around the beveled edge with light pressure
• Material has no warranty for fading. Fluorescent Neon colors tend to fade faster than normal colors. Fading can be reduced with over lamination, preventing stretched areas, which fade even faster, and shelter from high U.V. times during the day
• Due to different monitors/calibrations, colors may vary slightly from the pictures
• Film colors can vary slightly from roll to roll. For the most consistency, please purchase a full roll

Features of 6pcs 4x6 Purple Matte Flat Vinyl Wrap Emblem Overlay Sticker Decal Front Rear Film Sheet Not Pre-Cut Free Tool Kit

Made with an automotive-cast vinyl. Protects your paint from scratches and wear. Can be easily re-positioned and stretched for exact fitment and is soft enough to conform to all edges/contours/shapes. Creases and air bubbles can be removed by applying heat and using a squeegee. | We provide a tool kit set. We Limited 1 Set of Tool Kit for each buyer ONLY regardless of quantity purchase. | Included- (6) 6 by 4 Vinyl Sheets. (Not a precut letter) **Emblem not included** These are not precut because a vinyl sheet is easier to apply than a precut decal. | This Vinyl can be installed using Primer 94 and Edge sealer, these are recommended by vinyl wrap training class, these products will promote adhesion and add life to your vinyl. The sealer or primer will not remove the glue, deform the vinyl or ruin the texture unlike cheaper quality films.