AUTOSAVER88 2.5 Inch Inlet Black Exhaust Tip, 2.5" Inlet 3" Outlet 12" Overall Length Stainless Steel Exhaust Tips Powder Coated Finish Tailpipe

AUTOSAVER88 2.5 Inch Inlet Black Exhaust Tip, 2.5" Inlet 3" Outlet 12" Overall Length Stainless Steel Exhaust Tips Powder Coated Finish Tailpipe

Installation Steps:
Step 1: Clean the surface of your tailpipe.
Clean the dirt and sand on your tailpipe with penetrating oil and a shop rag.
(Make sure your tailpipe is at room temperature, and do not clean the surface of the tailpipe after the car just went out).
Step 2: Slide the exhaust tip into your tailpipe.
Try to slide the exhaust tip into the tailpipe. You may encounter some resistance, so, if necessary, use automotive grease to lubricate the pieces.
Cover the end of the exhaust tip with a towel and tap it into a place with a rubber mallet.
Step 3: Fasten/weld the exhaust tip.
Tighten screws and clamps to secure the exhaust tips. Should you worry that it is not tight enough, you can weld a joint between the edges of the tailpipe and the exhaust tip.
Then, the installation is complete.

Protect the Original Tailpipe:
Protect the original exhaust pipe from sun and rain to prevent rusting and deformation.

Nice Looking:
The black painting finish, elegant and mysterious, perfectly decorates the tailpipe of your car.

Specification:
Inlet Size: 2.5 Inch Inside Diameter
Outlet Size: 3 Inch Outer Diameter
Length: 12 Inch Overall Length
Material: Black Paint Finish Stainless Steel
Package: 1 piece exhaust tip.

Note: Please measure the size of your exhaust pipe prior to purchase of this exhaust tip.

Click "Add to Cart", Take the Cool Exhaust tip Home !!!