cciyu X27 168 Stepper Motor Repair Kit Replacement fit for Instrument Cluster Gauge(4 Motors,10 4.7mm Mimi Light Bulb)

cciyu X27 168 Stepper Motor Repair Kit Replacement fit for Instrument Cluster Gauge(4 Motors,10 4.7mm Mimi Light Bulb)

Compatiblity:
New generation steppers perfectly replace for the XC5.168 and X15.168
that are in your cluster from 2001 to 2006 General Motors instrument
clusters;that go bad in trunk and cars from 2003 to 2006,GM For GMC cars and
trucks

Specification:
Working Voltage: 5 to Voltage.
Low current consumption: less than 20mA, 5V, 2X100mW.
Extremely Robust Construction: 30mm X 7.6mm.
Directly driven by a controller

Features:
work in any gauge position and are the latest and greatest.
Each Gauge has a stepper motor and the item will fit almost all Gauges.
Quality Warranty, Money Back Guarantee

Fixed problems like(caused by Motor Stepper):
Gauge's sticking, shuttering,
chatters,inaccurate,
Gauge giving false readings,
staying pegging out
Gauge dead,etc

Package Including
4Pack x27.168 Stepper Motors
10Pack 4.7mm Mimi Light Bulb

Features of cciyu X27 168 Stepper Motor Repair Kit Replacement fit for Instrument Cluster Gauge(4 Motors,10 4.7mm Mimi Light Bulb)

THE LATEST GENERATION STEPPER MOTOR REPAIR KIT - 4Pack x27.168 Stepper Motors,10Pack Mimi Light Bulb.Replace for the older and faulty XC5-168, X15-168 ,X25-168 and X27-168 | FIXED PROBLEMS LIKE(Caused By Motor Stepper):Gauge's sticking, shuttering;chatters,inaccurate;Gauge giving false readings;staying pegging out;Gauge dead,etc. | APPLICATION: For Instrument Panel,Gauge Cluster,Temp Gauge,Tachometer,Speedometer | HOW TO INTALL:Before the solder paste on the mounting dip four pins new motor mount point solder with a soldering iron, and the motor mounting feet and the circuit board, and then use hot iron edge to edge Ann Zero press back in place on it, insert the needle as long as you pay attention to the zero pressure can be pressed, remember not to edge pressure | NOTE:Make sure you can handle this work, it may need some professional equipment of PC Boards.The new motor is installed, pay attention to see if it is installed, and then energize step on A foot accelerator, wait 3 seconds, as far as possible to avoid manual rotation of the motor, so as not to damage the motor speed ratio, and then look at the dashboard to see if it working properly.