MBS Mfg Compatible for Harley Davidson TC 96 103 110 Dyna Twin Inner Cam Bearing Installer Puller

MBS Mfg Compatible for Harley Davidson TC 96 103 110 Dyna Twin Inner Cam Bearing Installer Puller

Compatible for all TC96, 103 and 110s that use the B168 bearings. This set will remove and install the inner cam bearings on newer model Twin Cams and Dyna Harleys. We also have new Torrington-Koyo B-168 bearings. This set includes 1 " collet .The design of our collet is improved. The design sold by others has the whole back of the collet threaded with two slots cut into the threads for turning a wrench on. It's simple, it's cheap, and it's bad. Use that design once or twice, and you may vandalize the threads where the wrench makes contact, requiring you to now clean up those threads before you can even get the nut off the collet and use it again. We've worked around this issue by moving the threads up on the collet to allow for a more controlled grip and protection of threads. We've also completely redesigned the installer plate, zeroing in on the correct hole placement by taking apart an engine and putting it on a digital drafting table to get the precise placement of all of the important dimensions. Instructions are available for this set, please send us an email if you would like to get a copy of the instructions emailed! 100% Made in the United States.

Features of MBS Mfg Compatible for Harley Davidson TC 96 103 110 Dyna Twin Inner Cam Bearing Installer Puller

Compatible for all TC96, 103 and 110s that use the B168 bearings. This set will remove and install the inner cam bearings on newer model Twin Cams and Dyna Harleys. We also have new Torrington-Koyo B-168 bearings.

This set includes 1 " collet .The design of our collet is improved.

This set comes with our "T" pin for easier insertion and removal from the collet! But the BIGGEST improvement of this set is in what is NOT there. We have completely reworked how the process of pulling and installing the bearings works - we've made it easier, faster, and better. Instead of using a sleeve, nut, and washer with the collet to pull the bearings, the collet is threaded through the plate, and is inserted into the bearing.

Made in USA